Antwort #6 zu: MG5450: Blauer Schatten/ verschwommenes Druckbild
forum › Tintendrucker von Canon - 27.02.2017, 10:40
Der Druckkopf ist beschädigt. CL-Cyan-Düsen werden deformiert.Man kann deformierte Düsen mit bloßem Auge oder Makrofotografie sehen.Antwort #5 ist Spam, Werbung.mehr...
Antwort #11 zu: Canon MG 5250
forum › Tintendrucker von Canon - 23.02.2017, 21:53
Ja!1. Druckkopf mod und2. Treiber einrichtung.mehr...
Antwort #7 zu: Hackangriff auf Xerox-Drucker - Schüler hackt Xerox-Geräte
forum › DC-Artikel - 18.02.2017, 21:55
"Madcat, Jaguar Madcat!" :)mehr...
Antwort #7 zu: Tribut nach Durchstich-Methode
forum › Refill - 09.02.2017, 19:25
Danke für die Antwort."Sieht aus wie Eine Patrone kompatible."Ja. Mit diesen verwende ich. PGI-520/525 (x20/x25)."Und was ist da der vorteil mit der Nadel in sterben Kammer gerade zu gehen ..."1. Passen die Standard-Nadel von 40 mm aus der Apotheke.2. Ohne Öffnung, durch diemehr...
Tribut nach Durchstich-Methode
forum › Refill - 28.01.2017, 19:51
Leicht überarbeitete Durchstich-Methode.Die gebogene Nadel wird über eine Entlüftungsöffnung positioniert.mehr...
Antwort #3 zu: "Das Ding" auf meinem Druckkopf
forum › Tintendrucker von Canon - 28.01.2017, 14:47
Thanks for the response.It was an aftermarket single-use ink tank (cheap).98% of such inexpensive single-use ink tanks are OK.That one was defective.I poured a mixture of water and IPA (1 : 2 - 66% IPA) to the ink tank. The mixture of IPA and water was to be the beginning of themehr...
"Das Ding" auf meinem Druckkopf
forum › Tintendrucker von Canon - 26.01.2017, 18:56
Hallo,Bitte werfen Sie einen Blick auf das, was ich auf einem meiner Druckköpfe finde.Der Druckkopf war innerhalb von Pixma MG5250 auf einem Regal mehr als ein halbes Jahr."Das Ding" wuchs aus gelben Düsen, weil die gelbe Tinte schlecht wird. Schlechte gelbe Tinte ist dunkler,mehr...
Antwort #22 zu: Druckprobleme mit Pixma Pro 9500
forum › Tintendrucker von Canon - 19.01.2017, 18:32
Das bild in Antwort #7 ist "Druckkopfausrichtung".Wi r möchten "Düsentest " zu sehen.mehr...
Antwort #17 zu: Druckprobleme mit Pixma Pro 9500
forum › Tintendrucker von Canon - 19.01.2017, 12:33
I don't think it is because of broken printhead - the alignment sheet from post #7 looks OK.By performing printing nozzle check pattern one can judge condition of the printhead.It would be wise to perform printing text as .jpg from picture bridge front USB connector in order tomehr...
Antwort #6 zu: Druckprobleme mit Pixma Pro 9500
forum › Tintendrucker von Canon - 17.01.2017, 19:41
Cleaning line feed (disc) encoder or carriage encoder is risky.To me it looks like problem with line feed paper movement but not the disc encoder itself.How about performing some prints from front USB picture bridge connector?For example text converted to .jpgAre those prints inmehr...
Antwort #9 zu: TS8050 - Ich bin begeistert
forum › Lesermeinungen - 12.01.2017, 21:31
Hallo Scorpio,Haben Sie die Markierung auf dem Druckkopf überprüft? Ist es QY6-0083?Lukemehr...
Antwort #3 zu: Produktionsziel erreicht?
forum › Tintendrucker von Canon - 10.01.2017, 18:37
"Drucker liefert nur leere Blätter, aber keine Fehlermeldung!"http://www .druckerchannel.de/forum.p hp?seite=beitrag&ID=299590 &t=drucker_liefert_nur_lee re_blaetter_aber_keine_feh lermeldung#AW5mehr...
Antwort #3 zu: Bauteil "Bürste" bei drucken rausgezogen - wie wieder einbauen?
forum › Tintendrucker von Canon - 28.11.2016, 22:44
That part is intended to collect static electricity from sheet of paper - printer can go fine without that part.Yes, it is hard to detach print engine from bottom cover, especially in MFP.If the printer is performing fine without that part then don't care.Good moment to installmehr...
Antwort #1 zu: Bauteil "Bürste" bei drucken rausgezogen - wie wieder einbauen?
forum › Tintendrucker von Canon - 28.11.2016, 09:54
Hi,it is should be attached to duplexer entry guide. In order to put it back in place: one have to detach print engine from the bottom cover (same way like in case of cleaning absorber pads). Duplexer entry guide is located on the bottom of print engine.Some photos from iP4950mehr...
Antwort #4 zu: Drucker liefert nur leere Blätter, aber keine Fehlermeldung!
forum › Tintendrucker von Canon - 23.11.2016, 10:41
Hi,there is simple test one can perform to check if motherboard is ok.But I'm afraid using ultrasonic bath have rendered printhead useless already. Here is a test pattern to get color print, I hope Powdi will explain details in native forum language.Lukaszmehr...
Antwort #15 zu: Canon IP 4600 Duplexdruck
forum › Tintendrucker von Canon - 12.11.2016, 09:41
Hi,there is no dedicated duplex sensor in gen. x20/x21 (eg. iP4600) and x25/x26 printers.Leading/ending edge of the page have to strike PE sensor flag in specified time. If page is delayed then error is reported.Enter guide for duplexing unit is located behind line feed shaft nadmehr...
Antwort #7 zu: dunkler Druck bei Einstellung "Fotopapier"
forum › Tintendrucker von Canon - 01.11.2016, 15:42
Hi,nozzle check is abnormal because CL-BK bar is lighter than CL-GY bar.Budze is also alright - CL-BK nozzles are distorted.Cheers,Lukaszmehr...
Antwort #3 zu: Fehlercode: B200
forum › Tintendrucker von Canon - 02.08.2016, 17:37
Try following (picture).Example of use (dissabling both PGBK and CL):http://www.druckercha nnel.de/device_info.php?ID =2884&t=canon_pixma_mg5250 Somewhere step-by-step instructions posted on DC forum but can't find them now.Lukaszmehr...
Antwort #5 zu: Fehlermeldung B200 beim Canon Pixma MP980
forum › Tintendrucker von Canon - 04.06.2016, 11:18
Hi,pin masking technique is also possible for MP980, one can try.About pin masking technique (answer #15):http://www.druckerch annel.de/forum.php?seite=b eitrag&ID=283405&s=2#comme ntsMask for printhead used in MP980 are in attachments.No. 2 is most likely to work.Tip: if one ismehr...
Antwort #1 zu: Wo ist die "Anzahl an gedruckten Seiten" gespeichert?
forum › Tintendrucker von Canon - 02.06.2016, 22:05
Hi,1401-1450 is rounded value of total page count for printer itself.The printhead does not store page count. I have checked that.For brand new printhead one can buy brand new MG5650 and get set of startup OEM cartridges for free.Lukaszmehr...
Offenlegung - Provisionslinks
Wir erhalten bei einer Vermittlung zum Kauf oder direkt beim Klick eine Provision vom Anbieter.
Alle Preise enthalten die derzeit gültige MwSt. und verstehen sich zzgl. Versandkosten. Der Preis sowie die Verfügbarkeit können sich mittlerweile geändert haben. Weiß hinterlegte Preise gelten für ein baugleiches Gerät. Alle Angaben ohne Gewähr.
07:37 | |
00:42 | |
23:26 | |
23:21 | |
22:48 | AW #11: Drucker für Etsy-Shopmaximilian59 |
14:09 |
Multifunktionsdrucker (Pigmenttinte) |
|
Multifunktionsdrucker (Tinte) |
|
Multifunktionsdrucker (Tinte) |
|
Multifunktionsdrucker (Tinte) |
|
Multifunktionsdrucker (Pigmenttinte) |
|
Multifunktionsdrucker (Pigmenttinte) |
|
Multifunktionsdrucker (Pigmenttinte) |
|
Multifunktionsdrucker (Tinte) |
|
Multifunktionsdrucker (Laser/LED) |
|
Multifunktionsdrucker (Pigmenttinte) |