1. DC
  2. Forum
  3. Tintendrucker
  4. Epson
  5. nach Patronenwechsel keine gelbe Farbe mehr im Ausdruck

nach Patronenwechsel keine gelbe Farbe mehr im Ausdruck

Dieses Thema ist inaktiv: weitere Antworten sind nicht mehr möglich. Sie können jedoch ein neues Thema erstellen.

von
Hallöchen,ich habe kürzlich eine neue gelbe Farbpatrone einbauen müssen, da die alte leer war, aber sie druckt nicht, d.h. es fehlt das Gelb. Die Patrone ist original von Epson, sie hat ein Verfallsdatum vom nächsten Jahr, in ihr gluckert es, sie war ordnungsgemäß eingeschweißt und - soweit ich das als Laie beurteilen kann - äußerlich intakt. Ich hab sie eingebaut, wie alle anderen Patronen vor ihr auch. Das Druckerprogramm erkennt, dass sie voll ist, aber sie druckt eben nicht. Die elektronischen Kontaktflächen an der Patrone und im Drucker sehen soweit auch o.k. aus. Was kann ich machen, um doch noch zu einem gelb zu kommen?mfgDanni
von
Noch mal raus und rein. Ansonsten reklamieren. Es ist ja schließlich nicht auszuschließen, das bspw. der Chip oder die Patrone allg. doch einen kleinen defekt hat.
von
Raus und wieder rein. Wenn er dann net will, wie steps sagte ab zur Rekla...
von
Ja, klingt nach einer defekten Patrone (Fertigungsfehler, welcher Art auch immer).
von
Hallo! Diese ist eine wellbekannte probleme mit C82 .Es ist ein Schlauch unter dem serviceplatte in recht seite in die printer. Das SChlauch muss angeschlussen werden.


What i can see you have a Epson C82.That printer have problems
with the the tubeassembling for cleaning printhead and filling up printhead after changing patron. A tube can be disconnected.

Look at:www.maxpatchink.com/...

There can you see how to handle it!
Of course! If the tubeassembling is blocked by dried ink it will be
the same resultat :
1 Headcleaning is not effective
2 Filling up the inkhead after changing patrones is not working.
Beitrag wurde am 17.11.05, 19:03 Uhr vom Autor geändert.
von
Hello Larsas,I looked at the tube, but unfortunatly this is not the problem with my printer - the tube is exactly there where it should be. If the tube were off, each ink would surely be missing, or? Only the yellow ink is missing on my prints...Nevertheless thanks for your advice, Danni
von
You must look very carefully that the plastic tube is still on the nippel The rubber tube that is connected to the underside of the plate is no problem.It is difficult to see that the plastictube is still on.

As long as you don t move any patron you have no problem with
that patron.The tube assembling is only for headcleaning and filling
the channels down to the printnozzles so it is free from air.After
that the system is working by it self.Of course airleakage is not allowed from patron to channels so it must be clean surfaces between patron and printhead and the patron must be in bottom.
I
Beitrag wurde am 01.11.05, 17:30 Uhr vom Autor geändert.
von
I looked once again, the long transparent white tube is on the short black rubber tube and this is on the nipple of the plate. For a test I moved every other patron out and in and then I make a print, but there is all right, except the yellow ink...
von
Hallo again !!

It is probably something wrong with the patron :
Ventilationsopening up on the label side is not open .The valve in the botten is wrong so it dont open when you press the patron all way down.Inside the originalpatron is not any foam it is some kind
of sofisticated vacuumsystem inside the patron. Something can have been wrong when it was filled on the factory.(difficult to refill)
Perhaps the pin in bottom there you place the patron is blocked by something.

If you don t see anything wrong outside it try a new one .
Beitrag wurde am 01.11.05, 17:13 Uhr vom Autor geändert.
von
Hallo

Before you try with new patron you should try to clean the printhead with warm wet papertowels that you place under the printhead when it is outside the right side and the main cable off.
Use the leweladjustment on right side to lift the print head and sink it over the paper Repeat that a couple of times with warm wet paper look at the paper if you have yellow on the paper.Make a headcleaning and nozzle check .And check if it has made some result on the yellow.

If you need to do a lot of headcleaning after that a good idee can be to use
cheap ink .I did that with god result!After that I returned to original ink.
Beitrag wurde am 01.11.05, 06:35 Uhr vom Autor geändert.
von
Have you fixed your printer now?
1

Offenlegung - Provisionslinks

Wir erhalten bei einer Vermittlung zum Kauf oder direkt beim Klick eine Provision vom Anbieter.

Alle Preise enthalten die derzeit gültige MwSt. und verstehen sich zzgl. Versandkosten. Der Preis sowie die Verfügbarkeit können sich mittlerweile geändert haben. Weiß hinterlegte Preise gelten für ein baugleiches Gerät. Alle Angaben ohne Gewähr.

Forum Aktuell
07:57
07:32
00:04
22:47
21:17
15:35
Artikel
27.04. Brother L5000-​ und L6000er-​Serie: Gehobene Monolaser mit und ohne Scanner
24.04. Epson Readyprint Ecotank: Größere Druckerauswahl fürs Tintenabo mit Leihdrucker
23.04. Epson ReadyPrint Flex: Neue Vieldrucker-​Tarife fürs Tintenabo
18.04. The Recycler Live 2024: HP will wohl Chip-​Reset für professionelle Aufbereiter ermöglichen
17.04. Xerox Laserdrucker-​Cashback 2024/04: Bis zu 300 Euro zurück beim Kauf eines Laserdruckers mit Toner
16.04. CVE-​2024-​2209: Schwachstelle bei Deskjet-​Einstiegsmodellen
11.04. Brother ADS-​1800W und ADS-​1300: Einklappbare Dokumentenscanner mit USB-​C
10.04. HP zu SMTP-​Fehlern bei Laserjet und Officejet: Probleme beim E-​Mailversand sollen behoben werden
05.04. Epson Workforce Enterprise AM-​C400 und AM-​C550: Linehead-​Tintendrucker als kompakte A4-​Systeme
04.04. HP EvoMore-​Tintenpatronen: Nachhaltig? Für die Umwelt oder als Einnahmequelle?
22.03. Roland DG: Brother bietet für Großformat-​ und Industriedruckerhersteller
21.03. HP Instant Ink Platinum (Spanien): Weiteres Abo mit Druckermiete wird pilotiert
Themen des Tages
Beliebte Drucker
Neu ab 6.750,80 €1 Lexmark CX942adse

Multifunktionsdrucker, A3 (Laser/LED)

Neu   Lexmark CX943adtse

Multifunktionsdrucker, A3 (Laser/LED)

Neu   Lexmark CX931dse

Multifunktionsdrucker, A3 (Laser/LED)

Neu ab 5.582,81 €1 Lexmark CX931dtse

Multifunktionsdrucker (Laser/LED)

ab 174,00 €1 HP Smart Tank 5106

Multifunktionsdrucker (Tinte)

ab 184,95 €1 Epson Ecotank ET-2811

Multifunktionsdrucker (Tinte)

ab 72,46 €1 HP Deskjet 2821e

Multifunktionsdrucker (Tinte)

ab 304,29 €1 Epson Ecotank ET-4850

Multifunktionsdrucker (Tinte)

ab 738,99 €1 Epson Ecotank ET-5850

Multifunktionsdrucker (Pigmenttinte)

ab 164,90 €1 Canon Maxify MB5150

Multifunktionsdrucker (Pigmenttinte)

Merkliste

×
Drucker vergleichen