Errormeldung 922/924 Lexmark T610

Dieses Thema ist inaktiv: weitere Antworten sind nicht mehr möglich. Sie können jedoch ein neues Thema erstellen.

von Kubi12.05.2005, 14:38 Uhr

Habe Problem mit einem T610 und zwar bringt der mir die Fehlermeldung 922 Fuser Error!
Da ich schon die Fixiereinheit und das Conecting Board und das Main Logik Board getauscht habe gehen mir langsam die ideen aus wovon der Fehler erzeugt wird! Netzteil ist auch in Ordnung!
Kann mir irgendjemand noch weitere Tips zu dem Problem sagen?

MfG Kubi

von janfranck12.05.2005, 14:51 Uhr

hallo,

hier mal die lexmark error codes:

Lexmark Errors
Error 20 Input Paper Sensor was not triggered. Paper may be jammed at the sensor. Remove toner cartridge for better access to jammed paper Replace pick up rollers

Error 21 The exit sensor was not tripped in time Check for paper jam

Error 22 The exit sensor was not tripped in time. Check for paper jam

Error 23 Jam at the duplex unit. Remove paper from duplexer

Error 24 The defined paper size is too short to print data as formatted. Change to correct paper size

Error 25 Input sensor tripped at wrong time.

Error 26 Duplex unit is installed but paper tray is not sensed.

Error 27 Envelopes/paper loaded are wrong size.

Error 28 Input sensor not made after pick attempt. Tray is empty or not installed, paper jam in entry throat, or printer is requesting a manual feed.

Error 29 The output bin sensor has not been tripped

Error 30 Top Cover Open or Print Cartridge Missing Make sure the spring-mounted pin on the print head shroud is installed properly and that it is detected by the ramp on the print cartridge as the cover closes. The pin should enter the tower on the HVPS and depress the cover switch.

Error 32 Wrong Print Cartridge installed . The installed print cartridge is not supported by the Optra printer

Error 37 Insufficient Collation Memory Memory is too full to collate the print job.

Error 38 38 Memory Full Memory used to store pages is full. To verify that the printer recognizes all the installed memory, go to the user menus and print the “Print Menus” test page. Make sure the memory shown on the printout matches the installed memory.

Error 39 Page too complex to print. To verify that the printer recognizes all the installed memory, go to the user menus and print the “Print Menus” test page. Make sure the memory shown on the printout matches the installed memory.

Error 43 Font card format not supported by printer

Error 44 Defective font card installed in font slot.

Error 47 Font Card Removed While Printing Printer needs data on removed card.

Error 52 Flash Full Not enough flash memory for data requested to be stored.

Error 53 Unformatted or Defective Flash Flash problem at POR or while

Error 54 Serial Error - Framing or parity error on serial.

Error 58 Duplex Not Attached Duplex is electrically connected but no longer mechanically attached, and printer top cover is closed.

Error 59 Duplex Cover Open Top cover of duplex unit is sensed open.

Error 62 Disk Full Not enough disk space for data that has been requested to be written to disk.

Error 63 Unformatted or Defective Disk The printer will ignore a disk it senses as defective. Run the Quick Disk Test. If the test fails, the disk is defective or the data on track1 is bad. If the Quick Disk Test passes but the disk does not work, run the Disk Test/Clean (2 hr. test). Replace the disk if instructed by the operator panel.

Error 7X Network Card Codes These user codes are documented in various network card user manuals

Error 80 Network Card Codes These user codes are documented in various network card user manuals.

Error 80 Printer has reached 200,000 prints without maintenance count reset. Install maintenance kit and reset maintenance message

Error 88 Toner Low Toner sensor detects low toner. Replace toner cartridge

Error 90X Software Error Unrecoverable software error. If one of these errors appeared during POST, or while the printer was idle (not printing or receiving data), or while trying to print one of the internal test pages, replace the system board. If the error appeared while sending a job from the host to the printer, turn the printer off, then turn it on and try again.

Error 917 Transfer Roll Error Cannot start servo operation. Verify correct cable connections from the Engine board to the HVPS. Make sure there is continuity between the transfer roller and its contact on the HVPS; replace the transfer roll if the continuity is correct. If there is no continuity, make sure the HVPS goes back when depressed, and make sure the left bearing of the transfer roll is making proper contact.

Error 920 Fuser Error Fuser is below temperature while printing. Replace fuser

Error 921 Fuser is below standby temperature when idle. Replace fuser

Error 922 Fuser failed to reach standby temperature. Replace fusesr

Error 923 Fuser is too hot while printing or when idle. Replace fuser

Error 924 924 Fuser Error - Open circuit detected in thermostat circuit. Replace fuser

Error 927 Fan Stalled Check fan for binding or defective bearing - Replace Fan

Error 928 Erase lamp assembly missing or disconnected

Error 931 Print head error - No first sync Replace printhead

Error 932 Lost hsync

Error 934 Print head Error - Lost Lock condition

Error 935 Print head Error - Mirror motor unable to reach operation speed

schätz mal das dein temperatursensor hinüber ist :-(
viel glück noch, bei fragen, einfach mail an mich ,

grüße jan :-)

von janfranck12.05.2005, 14:53 Uhr

Error 924 924 Fuser Error - Open circuit detected in thermostat circuit. Replace fuser

den mein ich natürlich aus der liste ...
grüße jan :-)

von Kubi12.05.2005, 16:21 Uhr

Die Fixiereinheit wurde schon getauscht!
Der Fehler wechselt zwischen 922 und 924!

MfG Kubi

Neu	ab 6.750,80 €1 Lexmark CX942adse Multifunktionsdrucker, A3 (Laser/LED)
Neu	Lexmark CX943adtse Multifunktionsdrucker, A3 (Laser/LED)
Neu	Lexmark CX931dse Multifunktionsdrucker, A3 (Laser/LED)
Neu	ab 5.582,81 €1 Lexmark CX931dtse Multifunktionsdrucker (Laser/LED)
	ab 174,00 €1 HP Smart Tank 5106 Multifunktionsdrucker (Tinte)
	ab 184,95 €1 Epson Ecotank ET-2811 Multifunktionsdrucker (Tinte)
	ab 72,46 €1 HP Deskjet 2821e Multifunktionsdrucker (Tinte)
	ab 304,29 €1 Epson Ecotank ET-4850 Multifunktionsdrucker (Tinte)
	ab 738,99 €1 Epson Ecotank ET-5850 Multifunktionsdrucker (Pigmenttinte)
	ab 164,90 €1 Canon Maxify MB5150 Multifunktionsdrucker (Pigmenttinte)

00:36	AW #4: Nozzle Check unvollständigxxMediumxx
00:04	AW #5: Neuer Drucker gesucht: Ersatz für Epson WF-4640DTWF WorkForce Proaxxa101
23:52	AW #7: Neuer Drucker - Merkwürdiges Geräusch nach ca 70 Seitenaxxa101
22:47	AW #3: Epson XP-322 - Druckkopf herausnehmbar zum Reinigen?Türk
21:17	AW #2: 3-in-1 und gute fotosGast_64958
15:35	✉ Papierstau bei bzw nach Fixiereinheit kn00

27.04.	Brother L5000- und L6000er-Serie: Gehobene Monolaser mit und ohne Scanner
24.04.	Epson Readyprint Ecotank: Größere Druckerauswahl fürs Tintenabo mit Leihdrucker
23.04.	Epson ReadyPrint Flex: Neue Vieldrucker-Tarife fürs Tintenabo
18.04.	The Recycler Live 2024: HP will wohl Chip-Reset für professionelle Aufbereiter ermöglichen
17.04.	Xerox Laserdrucker-Cashback 2024/04: Bis zu 300 Euro zurück beim Kauf eines Laserdruckers mit Toner
16.04.	CVE-2024-2209: Schwachstelle bei Deskjet-Einstiegsmodellen
11.04.	Brother ADS-1800W und ADS-1300: Einklappbare Dokumentenscanner mit USB-C
10.04.	HP zu SMTP-Fehlern bei Laserjet und Officejet: Probleme beim E-Mailversand sollen behoben werden
05.04.	Epson Workforce Enterprise AM-C400 und AM-C550: Linehead-Tintendrucker als kompakte A4-Systeme
04.04.	HP EvoMore-Tintenpatronen: Nachhaltig? Für die Umwelt oder als Einnahmequelle?
22.03.	Roland DG: Brother bietet für Großformat- und Industriedruckerhersteller
21.03.	HP Instant Ink Platinum (Spanien): Weiteres Abo mit Druckermiete wird pilotiert

Offenlegung - Provisionslinks

Merkliste


überall nach # suchen Eingabetaste