mein Farbdrucker zeigt nach Rundumversorgung mit Maintenance Kids (896 A+B) die Fehlermeldung: 2112
Nach Recherche im Netz finde ich folgende Erklärung:
Description: Developer motor YCM startup error
Developer motor YCM is not stabilized within 2 s since the motor is activated.
Causes: Defective connector cable or poor contact in the connector. Defective drive transmission system. Defective motor. Defective PWB.
Remedy: Defective connector cable or poor contact in the connector. Reinsert the connector. Also check for continuity within the connector cable. If necessary, replace the cable. Developer motor YCM and engine PWB (YC4)
Defective drive transmission system. Check if the rollers and gears rotate smoothly. If not, grease the bushings and gears. Check for broken gears and replace if necessary.
Defective motor. Replace the Developer motor YCM.
Defective PWB. Replace the engine PWB and check for correct operation.
(Quelle:printcopy.info/...)
Frage nun: Wo finde ich den Stecker für die Entwicklereinheit?
Also grob kann ich den Bereich wohl lokalisieren, da er ja vermutlich in der Nähe der Einheit ist. (Siehe Fotos)
Kann mir da eventuell jemand weiterhelfen?
Vielen Dank im Vorus und Glück auf! :)