während des Druckens hat es gepiet und jetzt hab ich den Error Code C5102.
Drucken nicht mehr nöglich.
---------------------------
Description:
Transport motor’s failure to turn
• The motor lock signal remains HIGH for a predetermined continuous period of time while the motor remains stationary.
Remedy:
1 Check the M1 connector for proper connection and correct as necessary. 2 Check M1 for proper drive coupling and correct as necessary. 3 Check the PRCB connector for proper connection and correct as necessary. 4 M1 operation check. 5 Change M1. 6 Change PRCB.
---------------------------
Das Webfrontend meldete:
Bildeinheit (Schwarz) verbraucht -> Hab ich gewechselt. Jetzt "Bereit".
PRCB hab ich gewechselt. -> Fehler noch da.
Jetzt könnte ich noch M1 wechseln.
Aber was ist das genau für ein Teil? Kann man das überhaupt noch kaufen? Lohnt es sich überhaupt noch Geld in den alten Druckler zu stecken? Oder wo könnte der Fehler sonst noch sein?
Grüße,
Maitre