27. März 2007

0

0

0Drucken

0

Workshop Change Waste-Ink-Tank Canon Pixma iP4000: Step 4: Lift the print engine

Finally you loosen four screws, which connect the print engine with the bottom.

One screw in front on the right side...

...one on the right side in the back...

...one on the left side in the back...

...and one on the left side in front.

Next you lift the print engine and put it aside. Some resistance can be overcome by a little bit of shaking the engine.

Waste ink run via hoses to the collector.

Put the print engine in a vertical position on a thick layer of paper.

Important: Find a suitable place for the print engine. Most of the time there is ink at it´s bottom, so put it down on a thick layer of paper or a foil in a vertical position.

Now you are, where you wanted to be: Here are the sponges.

Use disposable gloves to exchange the sponges. Memorize the position of the different sponges. We suggest to take a digital camera shot, this helps to reinsert the sponges correctly.

After lifting off the print engine you see the sponges.

Now take out the sponges. The first one...

...the second...

...the third...

..the fourth...

...and the rest of them.