ich habe bei dem MP830 schon mehrere Versuche unternommen in den Service Mode zu kommen und einen Testausdruck wegen des Resttintentanks zu machen (Fehlercode 5C10, bzw. 6A00 - leider ohne Erfolg.
Auch der Workshop vom Druckerchannel hilft nicht weiter :-(
In den Service Mode komme ich zwar, aber ein Ausdruck lässt sich leider nicht erstellen. Wer weiß weiter?
So kam ich in den Service Modus:
<Service mode ope ration procedures>
1) With the machine power turned off, while pressing the Stop/Reset button, press and hold th e ON/OFF button. (DO NOT release the buttons). The COPY button lights in green to indicate that a function is selectable.
2) While holding the ON/OFF button, release the Stop/Reset button. (DO NOT release the ON/OFF button.)
3) While holding the ON/OFF button, press the Stop/Reset button 2 times, and then release both the ON/OFF and Stop/Reset butto ns. (Each time the Stop/Reset button is pres sed, the Alarm LED and COPY butt on light alternately, Alarm in orange and COPY in green, star ting with Alarm LED.)
4) When the COPY button lights in green, press the Stop/Reset button the specified number of time(s) according to the function listed in the table below. (Each time the Stop/Re set button is pressed, the Alarm LED and COPY button light alternately, Alarm in orange and COPY in green, starting with Alarm LED.)
Die COPY und die Fehlerleuchte blinken danach abwechselnd, aber ein Ausdruck, z.B. nach 2x oder 4x RESET drücken kommt nicht.
Bitte dringend um Hilfe!
Vielen Dank schon einmal.
Super wäre natürlich auch eine bebilderte Anleitung ;-)